Civil Engineering MCQs for Structural Analysis Part 2

Structural Analysis MCQs | Civil Engineering MCQs for Structural Analysis

In this article, you will get all Structural Analysis MCQs with answers for best practices for competitive exams to crack competitive exams will always update our article and add more and more MCQs so bookmark and share the civil experience site for the future learning.

Here on civil experience best civil engineering website, you will get the best learning and study materials, article, pdf, ppt, reports, etc for Structural Analysis and others too so must join a civil experience blog and learn every day

Structural Analysis MCQs | Civil Engineering MCQs for Structural Analysis

In this article, you will get all Structural Analysis MCQs with answers for best practices for competitive exams to crack competitive exams will always update our article and add more and more MCQ so bookmark and share the civil experience site for future learning.

Here in civil experience best civil engineering website, you will get the best learning and study materials, article, pdf, ppt, reports, etc for Structural Analysis and others too so must join a civil experience blog and learn every day

A collision is said to be perfectly inelastic. if the coefficient of restitution ‘e’ is _____

[A] 1
[B] ∞
[C] Zero
[D] -1

ANSWER= [C] Zero

A collision is said to be perfectly inelastic. if the coefficient of restitution ‘e’ is Zero

The carryover factor in a prismatic member whose far end fixed is _____

[A] Zero
[B] 1/2
[C] 3/4
[D] 1

ANSWER = [B] 1/2

The carryover factor in a prismatic member whose far end fixed is 1/2

Bending moment at any section in a conjugate beam gives in the actual beam _____

[A] slope
[B] curvature
[C] deflection
[D] bending moment

ANSWER= [C] deflection

Bending moment at any section in a conjugate beam gives in the actual beam deflection

The shape for a solid circilar section subjected to bending about its diameter is

[A] 1.12
[B] 1.50
[C] 1.70
[D] 2.0

ANSWER = [C] 1.70

The shape for a solid circular section subjected to bending about its diameter is 1.70

Steel Beam theory method is used to analyze and design of

[A] Singly Reinforced Beam
[B] Doubly Reinforced Beam
[C] Column structures
[D] Both Singly and doubly r/f beam

ANSWER= [B] Doubly Reinforced Beam

Creep strains are caused due to

[A] Dead Loads
[B] Live Loads
[C] Both Dead Load & Live Loads
[D] None of the above

ANSWER= [A] Dead Loads

Modulus of rigidity is defined as, within elastic limit shear stress is proportional to

[A] Torsional strain
[B] Shear strain
[C] Circumferential strain
[D] Longitudunal strain

ANSWER = [B] Shear strain

The main reinforcement in a cantilever beam shall be at

[A] Bottom of the beam
[B] Top of the beam
[C] Middle of the beam
[D] Non of the above

ANSWER = [B] Top of the beam